Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Chapter 5: Configuration with web interface
98-169085-B Terminal settings 64
To select the preferred BGAN satellite
By default the terminal is set up to automatically find the most appropriate satellite to connect
to (Automatic mode). However, if you are located in an area with more than one BGAN satellite
available, you can select the satellite you prefer to use when the terminal registers on the
BGAN network. Do as follows:
1. In the Terminal settings page, locate the Satellite selection section.
2. Select the satellite you want to connect to, or select Automatic to let the terminal find the
most appropriate satellite.
3. Click Save.
To select the type of navigation system (GNSS)
To select which navigation system to use with your EXPLORER 323, do as follows:
1. In the Terminal settings page, locate the GNSS section (Global Navigation Satellite
System).
2. Select GPS, GPS and GLONASS or GPS and BeiDou.
3. Click Save. Note that it may take some minutes for the EXPLORER 323 to change the
navigation system.
To select the language
The default language of the web interface is English. You can change the language to French,
German, Russian, Spanish, Portuguese, Chinese or Japanese.
To change the language, do as follows:
1. In the Terminal settings page, locate the Language section.
2. Select a language from the list and click Save.