Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Chapter 5: Configuration with web interface
98-169085-B To use the logs 60
To use the logs
To access the logs
To access the Logs, select and select Logs from the menu. The Logs page contains:
• Call log: A list of all incoming, outgoing and missed calls since the log was last cleared.
• Data log: A list of all data sessions since the log was last cleared.
• Total counters: Totals for each type of service since the log was last cleared.
Date and time is the international UTC time, received from the satellite.
Call log (Non-M2M only)
The Call log shows:
• Outgoing calls shows the start time, receiving end phone number, duration, type,
termination cause and, if Call charges have been entered, estimated charge of each
outgoing call.
• Received calls shows the start time, calling phone number, duration, type and termination
cause of each incoming call.
• Missed calls shows the start time, calling phone number, type and termination cause of
each incoming call that was not received.
To clear the Call log, click the Clear call log button at the top.
Data log
The Data log shows:
• Standard data shows data usage, date and time, termination cause and estimated charge
of each Standard data session (if Call charges have been entered).
• For Non-M2M only: Streaming data shows the duration and type (such as 64 kbps),
date and time, termination cause and estimated charge of each Streaming data session (if
Call charges have been entered).
To clear the Data log, click the Clear data log button at the top.
Total counters
The total counters show:
• For Non-M2M only: Call session totals shows the total duration (hh:mm:ss) for each
call type since the log was last cleared. It also shows the estimated call charge for each call
type (if Call charges have been entered).
• Data session totals shows totals for each data connection type since the log was last
cleared. For Standard data the totals are shown as amount of data transferred (kB) and for
Streaming connections the totals are shown in duration (hh:mm:ss). It also shows the
estimated charge for each data type (if Call charges have been entered).
To reset the Total counters, click the Reset total counters button at the top.