Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Chapter 5: Configuration with web interface
98-169085-B Status information 58
The following status is available:
Terminal status:
• Status: The current status of the BGAN network. In the example in the previous page,
Data means a data connection is running. The status could also be e.g. Registering or
Ready.
• M2M SIM: Shows whether or not the BGAN SIM card is an M2M SIM (Yes or No)
• Current satellite: The satellite to which the EXPLORER 323 is currently registered.
• Spot beam: The type of spot beam currently used, e.g. Regional or Narrow.
• Signal strength: The signal strength of the BGAN connection.
• Antenna status: The status of the antenna, such as Sky scan, Tracking, Pointed etc.
• Airtime Provider: The provider of the BGAN services.
• Mounting calibration: The status of the calibration process that detects how the
EXPLORER 323 is oriented in relation to the vehicle. Can be Calibrating, Validating or
Completed. For details, see Mounting calibration on page 23.
• Local IP address: The local IP address of the EXPLORER 323. E.g. used to connect to the
web interface.
• Logged in as: You can log in as User or Administrator. this field shows how you are
logged in.
Position information:
• Status: Shows the status of the GNSS connection, e.g. if there is 2D fix, 3D fix or no fix.
• Position: The geographic position of the EXPLORER 323.
• GNSS: Shows which GNSS systems are currently used to obtain the position.
• Satellites used: Shows how many GNSS satellites are used to obtain the position.
Data information (only shown if a data connection is running):
• Standard data: Shows that a Standard data connection is running on the Standard data
connection package.
• Streaming xxx kbit/s: Shows that a Streaming data connection is running (not possible
with M2M subscription).
Call information (only shown if a voice call is ongoing, not possible with M2M subscription):
• Status: The status of the call, e.g. “Connected” or “Ringing”.
• Call type: Shows the call type (Standard voice).
• Call duration: The duration of the call.
• Originator: The phone number from which the call was made.
• Receiver: The phone number that receives the call.