Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Chapter 5: Configuration with web interface
98-169085-B Multiple data connections 55
The new connection package is now on the startup page (Dashboard).
When you have started this connection package and traffic is detected on the LAN or WLAN
interface, the filters are used to route the traffic. E.g. if you connect your video equipment with
UDP traffic to the EXPLORER 323, your video transmission will use the connection that has
UDP in the filter settings (64 Streaming in the example above).
Automatic Context Activation (ACA)
To enable Automatic Context Activation of your Standard data connection, do as follows:
1. From the Dashboard, click
in the right side of the tile with the connection package that
you want to change.
2. Select Parameters.
3. Select Automatic Context Activation (ACA) of Standard data.
•When you select ACA, the data connection is automatically established after restart as
soon as the EXPLORER 323 and its BGAN connection are ready.
•When you disable ACA, you can control the data connection manually from the startup
page
or with the SMS command ACTIVATE.
Note
You are charged for the data transferred. You may want to disable automatic
updates in your LAN device to avoid unnecessary charges.