Installation Manual

Chapter 5: Configuration with web interface
98-169085-B To set up your data connection packages 49
To set up your data connection packages
Connection packages
To change the contents of a connection package
You access the connection packages from the Dashboard.
• To access the Dashboard click
 at the bottom of the page.
• To change the contents of a connection package, click
 in the right side of the tile with
the connection package.
Note
You must be logged in as administrator to be able to change the settings for a data
package.
If you want to Do as follows
Run one connection at a
time from the startup
page.
This is the default setup, with only one connection in each
connection package.
Start the connection you need from the web interface or the
display.
Use different connection
types for different types
of traffic.
Add more connections to a connection package and apply filters
to assign different connection types to different types of traffic.
See To create a package with multiple connections on page 52.
Start all the connections in the package by starting the package
from the web interface or the display.
If you want to Do as follows
Change the name of the connection
package
Click Properties, type in the new name and click
Save. The new name is shown on the tile on the
startup page.
Delete a connection package Click Delete package
a
Note: You cannot delete Standard data.
a. If you accidentally delete a connection package, you can either create a new manually, or restore factory
settings. Note, however, that all changes to the configuration will be lost if you restore factory settings.
Remove connections from the
connection package
Click  in the tile with the connection you want
to remove.
Add a connection to the package See Multiple data connections on page 51.