Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Chapter 5: Configuration with web interface
98-169085-B The web interface 45
Overview of the web interface
When the web interface opens, the title bar shows the name of the product. The example
below shows the Support page.
The web interface consists of the following sections.
• Name of current page. Tap or click to refresh the page.
• Icon bars at the top and bottom are present on all pages and hold icons that give access
to status such as signal level as well as active alerts, when relevant. It also holds the icon for
the Control panel. For explanations of the icons, see the next section, Icons in the icon
bars.
• Breadcrumbs right below the icon bar show the current location in the menu system and
gives access to the higher levels in the menu.
• Contents section shows the contents of the selected page. This section is used for
viewing or changing settings, or for performing actions. On the opening page, this section is
used to start and stop data connections.
• Status section shows the status of the terminal and the network connection (BGAN),
position information, ongoing calls and data sessions etc. The Status section is not shown
on small screens. If the screen is small (e.g. on a smartphone), you can show/hide the status
by clicking at the bottom of the page.
Icon bar
Breadcrumbs
Name and icon of current page (on opening page: the name of the product)
Status
section
Icon bar
Contents
section