Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Chapter 4: To use the EXPLORER 323
98-169085-B Tracking and location reporting 42
Apart from the numbers above, the EXPLORER 323 uses the following dialing prefixes:
• #31# before the phone number will hide the callers phone number to the recipient.
• *31# before the phone number will show the callers phone number to the recipient where
it would otherwise be hidden, e.g. because the number is an ex-directory number.
Tracking and location reporting
The EXPLORER 323 can be used for tracking purposes. You can set up the terminal to report its
position to a server at certain time intervals or after moving a given distance.
To use the tracking feature you must either set up a tracking server or get a tracking solution
from your service provider. The EXPLORER 323 must be set up to match this server. For
information how to set up the EXPLORER 323, see To set up tracking and location reporting
on page 60. Once set up on both sides, the EXPLORER 323 will send position reports to the
server as specified.