Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Chapter 4: To use the EXPLORER 323
98-169085-B To make phone calls over BGAN (not M2M version) 41
• Codec priority: Highest priority codec type: G.711
To make or receive a phone call with EXPLORER 323
Connect your smartphone or IP handset as described in To connect a VoIP phone or
smartphone on page 29.
To make a call from the EXPLORER 323
To make a call, dial 00 <country code> <phone number> followed by off-hook key.
Example: To call Cobham SATCOM in Denmark (+45 39558800),
dial 00 45 39558800
If there was an error establishing the connection, the web interface of the EXPLORER 323
shows an error message.
To receive a call
By default, all phones connected to the EXPLORER 323 will ring when the mobile number is
called.
Information on missed calls is stored in the call log. You can see the call log in the web
interface (Control panel
> Logs > Call log).
To make a call to the EXPLORER 323
To make a call to a phone connected to the EXPLORER 323, dial + <Mobile number>
• + is the prefix used in front of the country code for international calls. This is 00 when
calling from countries in Europe and from many other countries.
• Mobile number. The first part of the mobile number is always 870, which is the “country
code” for the BGAN system. For information on the mobile number, refer to your airtime
subscription.
Local numbers and special functions
Overview
There are a number of local numbers and dialing functions available in the EXPLORER 323.
The following list shows the allocated local numbers and special-purpose numbers for the
EXPLORER 323.
Note
The user name and password must match the IP handset settings in the
EXPLORER 323. See To manage VoIP phones or smartphones on page 51.
Number Function
0 followed by one of the numbers
501-516 and off-hook key
Local call to one smartphone or IP handset.