Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Chapter 4: To use the EXPLORER 323
98-169085-B To access the terminal from a remote location 37
To access the terminal from a remote location
Remote access with SMS
You can perform a number of actions and some configuration on the EXPLORER 323 using
SMS commands.
1. Prepare the terminal for SMS commands as described in To set up remote access with
SMS on page 88.
2. Send an SMS from a trusted phone number to the mobile number of the terminal. The
text in the SMS must start with the SMS command and follow the syntax for the SMS
commands. Note that the remote SMS password (default: remote) must be included with
every command.
The following SMS commands are supported.
For an explanation of syntax and parameters, see SMS remote commands on page 120.
Remote access with the web interface
There are two methods of getting remote access to the web interface:
• Using the AT command _IREMWEB, e.g. sent in an SMS (ATCO command).
SMS command Function
ACTIVATE Activates BGAN data connections for the device(s) connected to the
EXPLORER 323.
DEACTIVATE Deactivates some or all the BGAN data connections for devices
connected to the EXPLORER 323.
CLEAR Deletes SMS messages in the EXPLORER 323.
GETINFO Gets information from the EXPLORER 323 such as call time, data usage,
GPS position and global IP address.
RESTART Restarts the EXPLORER 323.
WATCHDOG Gets or allows you to set the Connection watchdog parameters (Link
monitoring).
ADVWATCHDOG Gets or allows you to set the Terminal watchdog parameters.
ATCO Allows you to send AT commands in an SMS to the EXPLORER 323 which
returns the response in an SMS.
Note: The ATCO command only supports a subset of the AT commands,
see ATCO commands on page 98.
ADPWRST Resets the EXPLORER 323 administrator password to admin.
Note
When using remote access, the web interface may take a long time to load the pages,
because the Internet connection may be slow.