Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Chapter 4: To use the EXPLORER 323
98-169085-B Power mode functions 36
General power save settings:
• Idle time - Set the number of minutes without any activity before the terminal enters power
save state.
• Set whether or not the power save function should be prevented when a satellite
connection (PDP context) is open (only configurable with web interface).
You can configure the wake up methods and the general power save settings in the web
interface under Advanced > Power control. See Power save on page 90.
For configuration with AT commands, see the section To set up power save functions with AT
commands on page 137.
Power control pin function when Idle power save is selected
When you have selected Idle power save you can choose to enable the Power control pin in
the web interface.
Disabled: If the Power control pin is disabled, the state of the pin is ignored.
Enabled: If the Power control pin is enabled, the function is as follows:
You can set the polarity of the Power control pin, that is whether the pin should be active high
or low. Default is active low.
The function of the enabled Power control pin in Idle power save mode is:
Power control pin is active: The terminal is on and will stay on as long as the pin is active.
Power control pin is inactive: The terminal will go into power save state when the Idle time
has expired and none of the configured wake-up methods are active. See also the note in the
previous page)