Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Chapter 3: To get started
98-169085-B To start and stop data connections 24
To start and stop data connections
By default, you have to start a data connection manually when the terminal is ready and
connected to the BGAN network. However, you can enable automatic activation of a data
connection. See Internet and LAN connection modes on page 62.
To start and stop data connections on your EXPLORER 323, do as follows:
1. On the connected device, open your browser and type the IP address of the terminal
(default IP address: 192.168.0.1) in the address bar to access the web interface, or
On your smartphone, start the EXPLORER Connect app and select Terminal access.
2. Locate the connection package you want to start.
3. Click
to start the connection.
4. Click
to stop the connection.
For details, see To control data connections from web interface on page 47.
Note
The icons for starting and stopping connections are only active if the
terminal is ready and registered on the network. Otherwise you cannot start data
connections.
Note
Once a Streaming connection is started, the connection will run until you stop it.
You will be charged for the time you are connected.