Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Chapter 3: To get started
98-169085-B To enter the SIM PIN for the terminal 21
To enter the SIM PIN for the terminal
Do you need a SIM PIN?
To avoid having to enter a PIN at startup, you have two options:
•Enable Auto SIM PIN validation. See Auto SIM PIN validation on page 81.
With this option enabled, the EXPLORER 323 automatically sends the PIN to the SIM card
at every startup. Note that if you later want change the SIM card, you should first disable
Auto SIM PIN validation.
• Disable the use of a SIM PIN. See To enable or disable the use of a SIM PIN on page 80.
When the SIM PIN is disabled, the SIM can be used by other terminals without a PIN.
If you are using a SIM PIN in your system, you can enter the SIM PIN from the built-in web
interface. For details, see the next section.
For information on how to connect your computer, see To connect a computer to the LAN
interface on page 18 or To connect your WLAN-enabled device on page 19
To enter the SIM PIN using the web interface
To enter the SIM PIN
Do as follows:
1. On a computer connected to the terminal, open your browser and enter the IP address of
the terminal in the address bar (default IP address: http://192.168.0.1).
If your SIM card uses a PIN and the PIN has not yet been entered, the web interface will
open with an Enter SIM PIN popup.
2. Type in the PIN and click OK.
Important
If your EXPLORER 323 is used in an unmanned M2M system, you will not be able
to enter a PIN code. In this case we strongly recommend enabling Auto SIM
PIN validation in the web interface before using the system. See below.
Note
If you are asked for a PIN in the web interface and you select Cancel, you cannot
communicate on the network, but you can access all settings.