Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
98-169085-B ii
Safety summary 1
The following general safety precautions must be observed during all phases of operation, service
and repair of this equipment. Failure to comply with these precautions or with specific warnings
elsewhere in this manual violates safety standards of design, manufacture and intended use of the
equipment. Thrane & Thrane A/S assumes no liability for the customer's failure to comply with
these requirements.
Intended use
The EXPLORER 323 terminal is intended for land vehicular use.
Before installing this product, please contact the vehicle manufacturer to ensure that the vehicle is
in compliance with UNECE Regulation 10, clause 3.1.8, and to confirm details about the
mounting, cabling and location.
Observe marked areas
Under extreme heat conditions do not touch areas of the terminal that are
marked with this symbol, as it may result in injury.
Microwave radiation hazards
During transmission the antenna in this system radiates microwave
power. This radiation may be hazardous to humans close to the terminal.
When the system is powered, make sure that nobody gets closer than the
recommended minimum safety distance.
The minimum safety distance is 0.7 m to the side and above the terminal when the EXPLORER 323
is powered. The safety distance does not apply directly below the terminal, as the radiation forms a
hemisphere above the terminal.
La distance de sécurité minimale est de 0.7 m des parois ainsi que du haut de l'antenne lorsque
l'EXPLORER 323 est allumé. La distance de sécurité minimale ne s'applique pas au-dessous de
l'antenne car la radiation ne forme une sphère qu'au-dessus de l'antenne.
Install and use the terminal with care
Thrane & Thrane A/S assumes no liability for any damage caused by the terminal falling off the
vehicle or stressing the mounting base. It is the responsibility of the customer to ensure a safe and
correct installation of the terminal. The instructions in the Installation manual are only guidelines.
WARNING! Only skilled persons may install the EXPLORER 323.