Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Chapter 3: To get started
98-169085-B The EXPLORER Connect app 20
The EXPLORER Connect app
If you want to use your smartphone with the EXPLORER 323, install the EXPLORER Connect
app, which is available for iPhone at the App Store and for Android phones at Google Play. The
EXPLORER Connect app provides the following options from the main menu:
To access the EXPLORER Connect app, connect your smartphone to the WLAN access point
of the EXPLORER 323 as described in To connect your WLAN-enabled device on page 19, and
start the EXPLORER Connect app. To access the configuration settings select Terminal
Access. From this point you have access to the same settings as from the web interface.
To access the web interface
You can use the built-in web interface for configuration and operation of the EXPLORER 323.
To access the web interface, do as follows:
1. Start up the terminal.
For details, see To switch on the EXPLORER 323 on page 17.
2. Connect your computer or smartphone to the terminal, using LAN or WLAN as described in
the previous sections.
3. Open your browser and enter the IP address of the terminal in the address bar. The default
IP address of the terminal is 192.168.0.1.
4. Enter user name and password. You can log in as user or as administrator.
•Default for user: User id = user, Password = <serial number of the EXPLORER 323>
•Default for administrator: User id = administrator, Password = admin
If the terminal is waiting for a PIN, the web interface will start up on the page where you enter
the pin. Otherwise it will start up on the dashboard. For more information on the web interface,
see The web interface on page 44.
Tile Function
Satellite Phone Use your smartphone as a satellite phone when connected to the
EXPLORER 323. Not available with M2M subscription
Terminal Access Start and stop data connections and access all settings of the
EXPLORER 323
Pointing Not applicable to the EXPLORER 323
Dashboard See the terminal and connection status
Note
If you get a message saying Network Unavailable or Connection error it means you
are not connected to the EXPLORER 323. Check the connection and setup of your
WLAN.
Important
For security reasons, change the passwords after first login.