Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Chapter 3: To get started
98-169085-B To connect your WLAN-enabled device 19
To connect your WLAN-enabled device
Prepare the WLAN interface
The WLAN interface is disabled by default, so you must first access the EXPLORER 323 using
the LAN interface and then enable the WLAN interface in the web interface. Do as follows:
1. Connect a computer to the LAN interface as described in the previous section.
2. Open your browser and access the web interface as described in To access the web
interface on page 20.
3. Click
from the bottom right corner of the web interface to access the Control panel.
1. Click the WLAN icon at the top of the page.
2. To enable the WLAN interface, select Enable.
For details on WLAN configuration, see WLAN interface setup on page 65.
Connect your device
1. Switch on the EXPLORER 323.
2. Place your WLAN-enabled device (computer, tablet or smartphone) close to the
EXPLORER 323.
3. On your device, search for available WLAN networks.
4. Select the EXPLORER 323 WLAN access point when it appears in your list of available
wireless networks.
The default name is EXPLORER323.
Your device is now connected to the EXPLORER 323. In the web interface, the WLAN icon
shows the number of devices connected to the EXPLORER 323 via WLAN. Example:
For information on how to configure the WLAN interface in the EXPLORER 323, see WLAN
interface setup on page 65.
For information on how to set up the LAN network, see Terminal settings on page 61 and
Advanced LAN on page 68.
Note
You must enter a password. By default the password is the serial number
a
of your
EXPLORER 323 and the encoding type is WPA2-AES.
a. You find the serial number on the label on the bottom side of the EXPLORER 323.