Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Chapter 3: To get started
98-169085-B To switch on the EXPLORER 323 17
To switch on the EXPLORER 323
To use the ignition system
If you have connected the ignition system of your vehicle to the Remote on/off wire (blue wire
in cable) and enabled the Remote on/off function in the web interface, the terminal will switch
on/off when you start/stop the ignition of your vehicle.
When the ignition is switched off the terminal is in power save state, unless other conditions
keep the EXPLORER 323 from going into power save state. see Power mode functions on
page 34. For information on how to connect Ignition to the EXPLORER 323 cable, refer to To
connect Ignition on page 12.
If you are not using the EXPLORER Mobile Gateway, you must enable the Remote on/off
function in the web interface. For further information, see Power save on page 90.
To use a remote on/off switch
If an external switch is connected to the remote on/off pin in the DC connector, you may use
the remote switch to turn the terminal on and off. When the remote switch is off, the terminal
is in power save state, same function as with the Ignition described above.
Power up completed
When the terminal is switched on and ready, the LED in
the bottom of the terminal lights steady green.
If the LED is flashing green it has started up but is not
yet ready to communicate on the network. You can
access the terminal settings, but the terminal is not
ready to make calls or running data sessions until the
system is registered on the BGAN network. You may
have to enter a SIM PIN before the system can register.
For further information, see To enter the SIM PIN in
the web interface on page 99.
Note
In some cases, the system may reboot after power-on because of the high start-up
current.