Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
98-169085-B Before you start 16
Chapter 3
To get started
3
This chapter describes how to start up the system and make the first call or data session. It has
the following sections:
• Before you start
• To inser t the SIM card
• To switch on the EXPLORER 323
• To connect your WLAN-enabled device
• To connect to the LAN interface
• To enter the SIM PIN for the terminal
• To register with the BGAN network
• To make phone calls over BGAN
Before you start
Operation at high temperatures
Connector
There is only one connector on the terminal, placed on the side of the terminal. This connector
is used for both DC power and Ethernet. A dedicated cable is included with the terminal. For
details, see To connect cables on page 11.
SIM card
The EXPLORER 323 requires a SIM card to go online with BGAN. Without a SIM card you can
still configure the terminal, but you cannot make calls nor access the Internet.
Your SIM card determines whether your EXPLORER 323 is operating as an M2M terminal or as
a BGAN class 12 terminal.
WARNING! In very high ambient temperatures, do not touch
areas of the terminal that are marked with this symbol.