Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Chapter 2: To install the system
98-169085-B PTT connection example 15
PTT connection example
You can use the EXPLORER 323 with the EXPLORER Mobile Gateway
1
.
In the PTT solution, you connect the EXPLORER 323 to the EXPLORER Mobile Gateway through
the EXPLORER Connection Box as shown below.
For pinout and information on how to connect the units, see the Connections section in the
installation guide included with the EXPLORER Connection Box.
1. The EXPLORER Mobile Gateway is an IP-based communications device that supports
integration of satellite/LTE/3G/LAN backhaul and Land Mobile Radio.
Note
If you are using the EXPLORER Mobile Gateway with the EXPLORER 323, the Remote
on/off function will automatically be enabled. This means that the EXPLORER 323 will
normally be in power save state when the ignition is off. See Power mode functions
on page 34.
Number Description Cable
1
Power Supplied with EXPLORER Mobile Gateway
2
Ethernet Supplied with EXPLORER Mobile Gateway
3
DC power and Ignition from vehicle Not supplied
4
Combined power and Ethernet Supplied with EXPLORER 323
EXPLORER Mobile Gateway
EXPLORER Connection Box
EXPLORER 323
DC power and
ignition from vehicle