Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Chapter 2: To install the system
98-169085-B To connect cables 14
To connect Ethernet
Depending on your configuration, you can connect the Ethernet wires from the combined
cable to a switch, an EXPLORER Mobile Gateway or directly to a PC (using an RJ-45 connector).
Connect the Ethernet wires as follows:
1. Connect the wires 1, 2, 3 and 4 from the EXPLORER 323 cable according to the pinout
shown in the previous section Included cable on page 11.
If you prefer to mount an RJ-45 connector, connect the wires as shown below.
2. For further details on how to connect the LAN interface, see To connect to the LAN
interface on page 18.
E323 cable, LAN part RJ-45 connector, male
Pin
1
2
3
4
5
6
7
8
Connect the LAN foil shield to
the RJ-45 connector shield