Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Chapter 2: To install the system
98-169085-B To install the terminal 8
To mount the terminal fixed on the vehicle roof (recommended)
The terminal may be fixed on the roof of your vehicle using three M6 bolts (included) and
mounting spacers (already mounted). This solution requires that you drill three holes in the
roof of the vehicle.
To mount the terminal, do as follows:
1. Use the already mounted plastic spacers or use similar mounting plates of 10 mm height.
See the drawing below.
2. Based on the dimensions of the mounting plates, calculate and mark up the position of the
holes to be drilled in the roof of the vehicle. The drawing below shows the Drill Circle
Diameter for the bushings in the terminal. The bushings are 120° apart.
Important
Do not mount the terminal without the spacers! If you mount the E323
directly on a roof without the spacers, this will have a significant negative
impact on antenna performance.
Also, free airflow under the terminal is necessary for the ventilation hole in
the bottom of the terminal not to be blocked and to prevent over-heating.