Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Chapter 2: To install the system
98-169085-B To install the terminal 7
Important mounting notes
Line of sight
Place the terminal with free line of sight in all directions to ensure proper reception of the
satellite signal. Do not place the terminal close to large objects that may block the signal.
Condensation
In some cases there will be condensation inside the EXPLORER 323. A ventilation hole with a
Goretex membrane in the bottom of the terminal is designed to lead any humidity away from
the terminal.
Make sure the ventilation hole is not blocked.
See To mount the terminal fixed on the vehicle roof (recommended) on page 8.
To mount the EXPLORER 323
The terminal can now be installed on the roof of the vehicle. You may choose between these
methods:
• To mount the terminal fixed on the vehicle roof (recommended)
• Magnetic Mount Solution (optional). Attach the terminal using magnets underneath the
terminal.
Important
Make sure there is always a distance of 10 mm between any part of the
terminal bottom and the mounting surface. If you are not using the included
plastic spacers nor the magnets, use 10 mm spacers at each bolt.
Note
It may be necessary to replace the Gore-Tex breather at regular intervals if the
EXPLORER 323 is used in environmental conditions with high levels of dust.
Important
Before you install the EXPLORER 323, make a note of the serial number
found on the label on the bottom of the terminal. The serial number must be
used for two things:
• Password for accessing the user part of the web interface. See To access
and navigate the web interface on page 44.
• WLAN encryption key. See WLAN interface setup on page 65.