Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
98-169085-B 142
Glossary
Glossary
A
APN Access Point Name. The Access Point Name is used by the terminal operator to establish
the connection to the required destination network.
C
CS Circuit Switched. Circuit-switched networks require dedicated point-to-point connections
during calls.
D
DHCP Dynamic Host Configuration Protocol. A protocol for assigning dynamic IP addresses to
devices on a network. With dynamic addressing, a device can have a different IP address
every time it connects to the network.
DNS Domain Name System. A system translating server names (URLs) to server addresses.
E
ECEF The Earth-Centered Earth-Fixed or conventional terrestrial coordinate system rotates
with the Earth and has its origin at the center of the Earth. The X axis passes through the
equator at the prime meridian. The Z axis passes through the north pole but it does not
exactly coincide with the instantaneous Earth rotational axis. The Y axis can be
determined by the right-hand rule to be passing through the equator at 90 degrees
longitude.
F
FUP Firmware Upgrade Process.
G
GLONASS GLObal’naya NAvigatsionnaya Sputnikovaya Sistema. Global Navigation Satellite System
in English.
GNSS Global Navigation Satellite System. A satellite navigation system with global coverage.
Examples are GPS, GLONASS or BeiDou.
GPS Global Positioning System. A system of satellites, computers, and receivers that is able to
determine the latitude and longitude of a receiver on Earth by calculating the time
difference for signals from different satellites to reach the receiver.
H
HTTP HyperText Transfer Protocol. HTTP is the underlying protocol used by the World Wide
Web and this protocol defines how messages are formatted and transmitted, and what
actions Web servers and browsers should take in response to various commands.
HTTPS Hypertext Transfer Protocol Secure (HTTPS) is an extension of the Hypertext Transfer
Protocol (HTTP). It is used for secure communication over a computer network, and is
widely used on the Internet.