Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Appendix B: Command reference
98-169085-B AT commands 135
<protocol
number>
<protocol
number>
This number is uniquely assigned for the protocol being used. TCP is set to
6, and UDP is set to 17. The protocol number determines which protocol is
used by the traffic flow filter (0-255).
<source address
and subnet
mask>
<source address
and subnet
mask>
This is an IPv4 IP address and subnet mask (0.0.0.0.0.0.0.0 to
255.255.255.255.255.255.255.255). The first four numbers are the IP
address and the last four numbers are the subnet mask.
<source port
range>
<source port
range>
Source port range in the form From.To.
See <destination port range> for example.
<state> 0
1
Deactivate.
Activate.
<Traffic Class> 1
3
Streaming (not available for M2M subscription).
Standard data (Background).
<Transfer delay> 0
500
4000
0 ms, error correction is determined by the network
500 ms, error correction is disabled
4000 ms, error correction is applied
Parameter Values Meaning