Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Appendix B: Command reference
98-169085-B AT commands 133
Context management AT commands
The table below summarizes some of the most used AT commands for context management.
Parameters are explained in the table in the next section. For details, refer to the 3GPP standard
TS 27.007.
Command Parameters
+CGACT [<state>[,<cid>[,<cid>[,...]]]
+CGDCONT [<cid>[,IP[,<APN>[,<PDP_addr>[,<d_comp>[,<h_comp>[,<apn
uname>,<apn_passwd>]]]]]]]
+CGDSCONT [<cid>,<p_cid>[,<d_comp>[,<h_comp>]]]
+CGEQMIN [<cid>[,<Traffic class>[,<Maximum bitrate UL>[,<Maximum bitrate DL>[,<Guaranteed
bitrate UL>[,<Guaranteed bitrate DL>[,<Delivery order>[,<Maximum SDU size>[,<SDU
error ratio>[,<Residual bit error ratio>[,<Delivery of erroneous SDUs>[,<Transfer
delay>[,<Traffic handling priority>]]]]]]]]]]]]]
+CGEQREQ [<cid>[,<Traffic class>[,<Maximum bitrate UL>[,<Maximum bitrate DL>[,<Guaranteed
bitrate UL>[,<Guaranteed bitrate DL>[,<Delivery order>[,<Maximum SDU size>[,<SDU
error ratio>[,<Residual bit error ratio>[,<Delivery of erroneous SDUs>[,<Transfer
delay>[,<Traffic handling priority>]]]]]]]]]]]]]
+CGPADDR [<cid>[,<cid>[,...]]]
+CGTFT [<cid>[,<packet filter identifier>,<evaluation precedence index>[,<source address and
subnet mask>[,<protocol number (ipv4) / next header (ipv6)>[,<destination port
range>[,<source port range>[,<ipsec security parameter index (spi)>[,<type of service
(tos) (ipv4) and mask / traffic class (ipv6) and mask>[,<flow label (ipv6)>]]]]]]]]]