Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Appendix B: Command reference
98-169085-B AT commands 132
AT commands for message (SMS) configuration
The following AT commands are used for configuration of SMS.
Note
For details on parameters for the message configuration commands, see the 3GPP
standard ETSI TS 127 005 V4.2.1.
Command Parameters Function
+CMGD <index> Delete Message.
+CMGF <mode> Message Format.
+CMGL <stat> List Messages.
+CMGR <index> Read Messages.
+CMGS <da/mr>[,<toda/scts>] Send Message.
+CNMI [<mode>[,<mt>[,<bm>[,<ds>]]]] New Message Indications to TE.
+CPMS <mem1>[,<mem2>[,<mem3>]] Preferred Message Storage.
+CSCA <sca>[,<tosca>] Service Center Address.
+CSMP [<fo>[,<vp>[,<pid>[,<dcs>]]]] Set Text Mode Parameters.
+CSMS <service> Select Message Service.