Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Appendix B: Command reference
98-169085-B AT commands 127
<ip_addr_lo> <ip_addr_lo> IP address of the HTTP client that should be allowed remote access to the
EXPLORER 323,
or, the lowest address in a range of IP addresses, if a range of addresses is
allowed.
<local dir> <local dir> The name of the local directory in the EXPLORER 323 to use for getting or
saving a file.
<mode> 0
1
Deferred activation.
Immediate activation.
<new passwd> <new passwd> The new password to be used after this command. The password must be 5
to 15 characters long and cannot contain spaces.
Avoid special characters. Accepted characters: A through Z (uppercase
characters), a through z (lowercase characters) and 0 through 9 (numeric
characters).
<old passwd> <old passwd> The old password that is already in the system.
<type> AD
RS
The type of password is administrator password.
The type of password is remote SMS password.
Parameter Values Meaning