Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Appendix B: Command reference
98-169085-B AT commands 126
M2M related AT commands
The following tables summarize some of the most used AT commands for M2M operation.
Parameters are explained in Parameters for ATCO commands on page 126 and Parameters
for other M2M related AT commands on page 130.
ATCO commands
The table below summarizes the ATCO commands, i.e. AT commands that can be used in the
SMS command ATCO.
Parameters for ATCO commands
Command Parameters
_ICPWD
<type>,<old passwd>,<new passwd>
_IGETFILE
<ftp dir>,<filename>,<local dir>,<ftp server>,<ftp uname>,<ftp passwd>[,<apn>[,<apn
uname>[,<apn passwd>]]]
_IGETFW
<mode>[,<ftp server>[,<ftp uname>[,<ftp passwd>[,<apn>[,<apn uname>[,<apn passwd>]]]]]]
_IREMWEB
<enable>,<ip_addr_lo>[,<ip_addr_hi>][,<apn>[,<apn uname>,<apn passwd>]]
_ISENDFILE
<local dir>,<filename>,<ftp dir>,<ftp server>,<ftp uname>,<ftp passwd>[,<apn>[,<apn
uname>[,<apn passwd>]]]
_IUPDCFG
<filename>
_IUPDFW
<filename>
Parameter Values Meaning
<apn passwd> <apn passwd>Password for the APN.
<apn uname> <apn uname> User name for the APN.
<apn> <apn> APN name.
<enable> 0
1
Disable.
Enable.
<filename> <filename> The name of the file to use, including extension.
<ftp dir> <ftp dir> The name of the directory on the ftp server to use for getting or saving a file.
<ftp passwd> <ftp passwd> Password for the ftp server.
<ftp server> <ftp server> Host name or IP address of the ftp server.
<ftp uname> <ftp uname> User name for the ftp server.
<ip_addr_hi> <ip_addr_hi> The upper IP address of a range of allowed IP addresses. This parameter is
optional; if omitted, only the specified single IP address <ip_addr_lo> may
access the EXPLORER 323.