Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Appendix B: Command reference
98-169085-B SMS remote commands 124
SMS reject responses
Reject Response SMS Possible Cause
ACT/DEACT PARM PROBLEM The <IP addr> provided for an ACTIVATE or
DEACTIVATE command is incorrect (for
ACTIVATE, it must be in same subnet as the
EXPLORER 323 IP and not be the
EXPLORER 323 IP; for DEACTIVATE, it must
exist as a local or global IP address in the
existing PDP table).
ATCO ERROR Unable to send AT command to ATC handler.
COMMAND NOT SUPPORTED Attempt to use an SMS command not
supported by the EXPLORER 323.
ERROR: TERMINAL BUSY An ACTIVATE or DEACTIVATE command is
in progress.
INVALID RESTART REQUEST Attempt to perform restart before
EXPLORER 323 has been running for at least
15 minutes.
INVALID WATCHDOG PING ADDRESS Entered Ping address is out of range (0.0.0.0
– 255.255.255.254).
INVALID WATCHDOG PING FREQUENCY Requested Ping Frequency is less than the
minimum (5 minutes).
INVALID WATCHDOG REQUEST "Ping required" or "wdog enabled" fields
incorrect in remote SMS message, or
watchdog request other than "get"
attempted.
WRONG CONNECTION TYPE(NO DHCP TE) No DHCP TEs connected to the Remote Unit.
WRONG CONNECTION TYPE(NO STATIC TE) No Static TEs added in Terminal settings.
WRONG CONNECTION TYPE(NO TEs) No TEs are connected to the Remote Unit.
WRONG PASSWORD Authentication Failure.
WRONG QOS Invalid QoS Requested (only a QoS of 1 is
valid).