Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Appendix B: Command reference
98-169085-B SMS remote commands 120
SMS remote commands
This section describes syntax and parameters for the SMS commands. For examples of use, see
Remote access with SMS on page 37
Syntax conventions
Syntax definitions use the following conventions:
• <parm> indicates that a parameter (without < and >) can be filled in by the user.
• { <opt1> | <opt2> | … | NA } indicates that one of various options must be chosen by the user.
Use NA when no value is defined.
• Keywords and parameters are separated by the space (ASCII 32) character.
• The command name and all keywords must be in upper case; most user-provided
parameters are case sensitive but may be either case.
• TE means Terminal Equipment - the equipment connected locally to the EXPLORER 323.
SMS remote command summary
Commands
The table below summarizes the available SMS remote commands. The password comes just
after the last parameter (except for the ATCO command, see below).
Command Parameters Password
ACTIVATE <qos> <PC/TE type> <apn> <user> <pwd> <rsms_pwd>
ADPWRST 1 <imei> <rsms_pwd>
ADVWATCHDOG <get/set> <wdog_enable> <wakeup> <interval> <ping1> <ping2> <ping3>
<apn_type> <apn> <user> <pwd> <pos_response> <sms_number>
<rsms_pwd>
CLEAR <category> SMS <rsms_pwd>
DEACTIVATE <qos> <PC/TE type> <rsms_pwd>
GETINFO <info_mode> <dataset> <rsms_pwd>
RESTART <reset_type> BGAN <rsms_pwd>
WATCHDOG <wdog_op> <ping1> <ping2> <ping3> <ping_always> <ping_interval>
<wdog_enable>
<rsms_pwd>
ATCO <resp_mode> <rsms_pwd> <at_cmd>