Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Appendix A: Specifications
98-169085-B EXPLORER 323 terminal 115
Environmental specifications
Characteristics Specification
Water and dust IP66 (with cable inserted)
Ambient temperature
Operating
Survival
Storage
-25°C to +55°C at min. 1 m/s windload
-40°C to +80°C
-40°C to +85°C
Relative humidity up to 95% non-condensing at 40°C
Ice, survival Up to 25 mm of ice (non-operational)
Wind Relative wind speeds up to 200 km/h
Vibration, operational Random vibration of 1.05 G RMS in each of three mutually
perpendicular axes.
The spectrum of the vibration is as follows:
• 5 to 20 Hz: 0.02 G
2
/Hz
•20 to 150 Hz: -3dB/octave
Vibration, survival Random vibration of 1.7 G RMS for a period of two hours in
each of three mutually perpendicular axes (six hours total).
The spectrum of the vibration is as follows:
• 5 to 20 Hz: 0.05 G
2
/Hz
•20 to 150 Hz: -3dB/octave
Vehicle motion Turning rate: 40°/s
Turning acceleration: 50°/s²
Induced acceleration: 0.5 G
Velocity: Maximum vehicle velocity 110 km/h with the
Magnetic Mount Solution, 200 km/h for bolt mounting.
Shock, survival Half sine wave shock with a peak of 20 G and a period of
11 ms.