Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Appendix A: Specifications
98-169085-B EXPLORER 323 terminal 114
Power consumption
Power consumption at 12 V operation
Power consumption at 24 V operation
State of the terminal at 12 V
Typical power
consumption
Power save state (configured for Remote on/off)) 0.18 W
Idle (no active PDP context, LAN active) 3.9 W
Idle (no active PDP context, WLAN active) 4.1 W
Active PDP context - primarily received traffic (LAN active) 9.5 W
Active PDP context - primarily received traffic (WLAN active) 10.3 W
Active PDP context - primarily transmitted traffic (LAN active) 24.8 W
Active PDP context - primarily transmitted traffic (WLAN active) 25.7 W
Active PDP context - bidirectional traffic (LAN active) 26.9 W
Active PDP context - bidirectional traffic (WLAN active) 25.7 W
State of the terminal at 24 V
Typical power
consumption
Power save state (configured for Remote on/off)) 0.29 W
Idle (no active PDP context, LAN active) 3.8 W
Idle (no active PDP context, WLAN active) 4.0 W
Active PDP context - primarily received traffic (LAN active) 9.1 W
Active PDP context - primarily received traffic (WLAN active) 10.1 W
Active PDP context - primarily transmitted traffic (LAN active) 23.5 W
Active PDP context - primarily transmitted traffic (WLAN active) 24.3 W
Active PDP context - bidirectional traffic (LAN active) 25.4 W
Active PDP context - bidirectional traffic (WLAN active) 24.4 W