Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Chapter 6: Maintenance and troubleshooting
98-169085-B Troubleshooting 110
The terminal has re-registered due
to a high LTE blocker level
A cellular network signal is
interfering with the satellite
signal and caused the terminal to
reregister.
If possible, move the terminal to
another location with lower LTE
blocker level.
You can disable the LTE blocker
resilience with an AT command,
see _ILTEBLCK on page 130.
Too high temperature warning
High ambient temperature is
causing the performance of the
system to be degraded or halted.
The bit rate is reduced.
Wait for the terminal to cool
down. If possible, move to a
cooler place.
Too low temperature warning
Low ambient temperature is
causing the performance of the
terminal to be degraded or
halted.
Move the terminal to a warmer
place.
Unknown connection problem There is an unknown problem
with the connection.
Restart the connection e.g. from
the Dashboard in the web
interface. See Manual
activation of data connections
on page 30.
If the problem persists, contact
your airtime provider.
Displayed text Explanation Remedy