Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Chapter 6: Maintenance and troubleshooting
98-169085-B Troubleshooting 105
Troubleshooting
Status signaling
Means of signaling
The EXPLORER 323 system provides various methods for signaling the status of the system.
• LED in the bottom of the EXPLORER 323 is used to signal:
• Power on/off
• Status
•Software update
• Warnings
• Errors
• Event messages with warnings or errors are shown in the web interface.
LED signaling
The LED is located in the cover for the SIM compartment in the bottom of the terminal.
The functions of the LED are:
Light pattern Meaning
Green flashing rapidly Starting up.
Yellow flashing Antenna searching for BGAN satellite signal
Green flashing Antenna tracking on BGAN satellite signal.
Green constant Ready.
Yellow flashing rapidly Closing down.
Yellow constant Warning (user recoverable). See web interface for the warning text.
Red constant Error. See the web interface.
Blue flashing Uploading software to the terminal.
Blue flashing rapidly Safe mode.
Off Power off or Power save state.