Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Chapter 5: Configuration with web interface
98-169085-B Advanced settings 96
• Use local port filter.
This is a range of local port numbers on the terminal. The filter will route traffic to and
from any of these port numbers to the connection type associated with this traffic flow
filter.
• Use global port filter.
This is a range of global port numbers on the terminal. The filter will route traffic to and
from any of these port numbers to the connection type associated with this traffic flow
filter.
•Use type of service filter.
Type of Service (TOS) is used to define the Quality of Service. Set this value to a number
between 0 and 255.The filter will route traffic with this Quality of Service to the
connection type associated with this traffic flow filter.
• Use IPsec SPI filter.
IP security. The filter will route traffic using the Security Parameter Index (SPI) stated
here (in hexadecimal numbers) to the connection type associated with this traffic flow
filter.
7. Click Save.
The new filter will now be available for selection when you add new connections to a
connection package.
Example: You want a connection package, which allows you to use uninterrupted Voice over
IP while having a Standard data connection for web browsing etc. Do as follows:
1. Create a filter template with
• Protocol=UDP (Use protocol number filter)
• Type of Service = 0xb8 and Type of Service mask = 255 (Use type of service filter)
The UDP protocol is suitable for UDP voice streaming and the TOS value 0xb8 is used by
some linksys Voice over IP adapters.
2. Create a connection package as described in Multiple data connections on page 51.
3. Add an additional connection, e.g. Streaming 32 with the new filter you created in step 1.
4. Add a Standard connection with No filter.
Help desk
Under Help desk you can enter the contact information you want for your EXPLORER 323. The
Help desk contact information is empty by default. You must provide the contact information,
e.g. the phone number for your Airtime Provider. Do as follows:
1. In the Advanced page, select Help desk.
2. Type in the contact information you want.
3. select Save.
The Help desk information is now available from
(Control panel) > Support > About.