Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Chapter 5: Configuration with web interface
98-169085-B Advanced settings 93
To configure data connection types and filters
If the default connection types and filters do not meet your requirements, you can build new
templates for the connection types and/or traffic flow filters to match your needs.
Connection templates
To access the connection templates, do as follows:
1. Under Advanced, select Templates.
2. Select Connections.
3. To delete a connection type, click ? in the right side of the connection type.
4. To add a new connection type, click Add template and proceed with the next steps.
5. Select an existing Connection template as a basis for your new template.
6. Type in a suitable Name for the connection type.
7. Select the Traffic class.
• Standard is a shared, best-effort connection, used e.g. for email or Internet browsing.
• Streaming is an exclusive, high-priority connection with a guaranteed bit rate.
8. Select the following bit rates:
• Max. bit rate upload is the maximum upload bit rate allowed for this connection type.
• Max. bit rate download is the maximum download bit rate allowed for this
connection type.
• Guaranteed bit rate upload: For Streaming services this is the guaranteed upload bit
rate needed for this connection type.
• Guaranteed bit rate download: For Streaming services this is the guaranteed
download bit rate needed for this connection type.