Installation Manual
Table Of Contents
- Safety summary
- About this manual
- Introduction to EXPLORER 323
- To install the system
- To get started
- Before you start
- To switch on the EXPLORER 323
- To connect to the LAN interface
- To connect your WLAN-enabled device
- The EXPLORER Connect app
- To access the web interface
- To enter the SIM PIN for the terminal
- To register with the BGAN network
- Mounting calibration
- To start and stop data connections
- To make phone calls over BGAN
- To use the EXPLORER 323
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages
- Multiple data connections
- Status information
- The Control panel
- To use the logs
- Terminal settings
- To set up the interfaces
- To manage VoIP phones or smartphones (Not M2M)
- Advanced LAN
- To manage connected devices (Traffic control)
- To set up tracking and location reporting
- Support features
- Advanced settings
- Passwords
- To set up user permissions
- To restore factory settings
- SIM PIN for BGAN
- To save or load a configuration
- Connection watchdog (Link monitoring)
- Terminal watchdog
- Data limits
- Call charges
- Remote management
- Remote control of tracking
- Power save
- To configure data connection types and filters
- Help desk
- Reset button
- Security
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Specifications
- Command reference
- Conformity
- Glossary
- Index
Chapter 5: Configuration with web interface
98-169085-B Advanced settings 92
Remote on/off mode
1. In the Power control page, select Remote on/off from the drop-down list.
2. At Delayed shut down, select the wanted shut-down delay after the power control pin is
deactivated.
3. At Daily awake period, select Enable and enter the start time and duration of the awake
period, if you want the terminal to have a fixed awake period every day.
4. At Power control pin (Remote on/off), select the polarity of the power control signal
(Active high/Active low).
5. Click Save.
Important
Be aware that once you have enabled the Remote on/off function, the
EXPLORER 323 will be in power save state until you have connected the
Remote on/off wire and it is active, or one of the other conditions that can
prevent power save is present! See Power mode functions on page 34.
Note
Local time must be converted to UTC time!
Important
If you are connecting the power control pin to ignition, you must select
Active high, because the ignition signal in the vehicle is active high.