User's Manual
Table Of Contents
- 1 Device Overview
- Table of Contents
- 2 Revision History
- 3 Device Comparison
- 4 Terminal Configuration and Functions
- 5 Specifications
- 5.1 Absolute Maximum Ratings
- 5.2 ESD Ratings
- 5.3 Recommended Operating Conditions
- 5.4 Power Consumption Summary
- 5.5 General Characteristics
- 5.6 Antenna
- 5.7 1-Mbps GFSK (Bluetooth low energy) – RX
- 5.8 1-Mbps GFSK (Bluetooth low energy) – TX
- 5.9 2-Mbps GFSK (Bluetooth low energy) – RX
- 5.10 2-Mbps GFSK (Bluetooth low energy) – TX
- 5.11 IEEE 802.15.4 (Offset Q-PSK DSSS, 250 kbps) – RX
- 5.12 IEEE 802.15.4 (Offset Q-PSK DSSS, 250 kbps) – TX
- 5.13 24-MHz Crystal Oscillator (XOSC_HF)
- 5.14 32.768-kHz Crystal Oscillator (XOSC_LF)
- 5.15 48-MHz RC Oscillator (RCOSC_HF)
- 5.16 32-kHz RC Oscillator (RCOSC_LF)
- 5.17 ADC Characteristics
- 5.18 Temperature Sensor
- 5.19 Battery Monitor
- 5.20 Continuous Time Comparator
- 5.21 Low-Power Clocked Comparator
- 5.22 Programmable Current Source
- 5.23 DC Characteristics
- 5.24 Thermal Resistance Characteristics for MOH Package
- 5.25 Timing Requirements
- 5.26 Switching Characteristics
- 5.27 Typical Characteristics
- 6 Detailed Description
- 7 Application, Implementation, and Layout
- 8 Device and Documentation Support
- 9 Mechanical Packaging and Orderable Information
- Important Notice
PRODUCTPREVIEW
9
CC2650MOD
www.ti.com
SWRS187 –AUGUST 2016
Submit Documentation Feedback
Product Folder Links: CC2650MOD
SpecificationsCopyright © 2016, Texas Instruments Incorporated
(1) I
peri
is not supported in Standby or Shutdown.
5.4 Power Consumption Summary
T
c
= 25°C, V
DDS
= 3.0 V with internal DC-DC converter, unless otherwise noted
PARAMETER TEST CONDITIONS MIN TYP MAX UNIT
I
core
Core current consumption
Reset. RESET_N pin asserted or VDDS below
Power-on-Reset threshold
100
nA
Shutdown. No clocks running, no retention 150
Standby. With RTC, CPU, RAM and (partial)
register retention. RCOSC_LF
1
µA
Standby. With RTC, CPU, RAM and (partial)
register retention. XOSC_LF
1.2
Standby. With Cache, RTC, CPU, RAM and
(partial) register retention. RCOSC_LF
2.5
Standby. With Cache, RTC, CPU, RAM and
(partial) register retention. XOSC_LF
2.7
Idle. Supply systems and RAM powered. 550
Active. Core running CoreMark
1.45 mA +
31 µA/MHz
Radio RX 6.1
mARadio TX, 0-dBm output power 6.1
Radio TX, 5-dBm output power 9.1
Peripheral Current Consumption (Adds to core current I
core
for each peripheral unit activated)
(1)
I
peri
Peripheral power domain Delta current with domain enabled 20 µA
Serial power domain Delta current with domain enabled 13 µA
RF Core
Delta current with power domain enabled, clock
enabled, RF Core Idle
237 µA
µDMA Delta current with clock enabled, module idle 130 µA
Timers Delta current with clock enabled, module idle 113 µA
I
2
C Delta current with clock enabled, module idle 12 µA
I2S Delta current with clock enabled, module idle 36 µA
SSI Delta current with clock enabled, module idle 93 µA
UART Delta current with clock enabled, module idle 164 µA
(1) This number is dependent on Flash aging and will increase over time and erase cycles
5.5 General Characteristics
T
c
= 25°C, V
DDS
= 3.0 V, unless otherwise noted
PARAMETER TEST CONDITIONS MIN TYP MAX UNIT
FLASH MEMORY
Supported flash erase cycles before
failure
100 k Cycles
Flash page/sector erase current Average delta current 12.6 mA
Flash page/sector erase time
(1)
8 ms
Flash page/sector size 4 KB
Flash write current Average delta current, 4 bytes at a time 8.15 mA
Flash write time
(1)
4 bytes at a time 8 µs