User's Manual
Table Of Contents
- 1 Device Overview
- Table of Contents
- 2 Revision History
- 3 Device Comparison
- 4 Terminal Configuration and Functions
- 5 Specifications
- 5.1 Absolute Maximum Ratings
- 5.2 ESD Ratings
- 5.3 Recommended Operating Conditions
- 5.4 Power Consumption Summary
- 5.5 General Characteristics
- 5.6 Antenna
- 5.7 1-Mbps GFSK (Bluetooth low energy) – RX
- 5.8 1-Mbps GFSK (Bluetooth low energy) – TX
- 5.9 2-Mbps GFSK (Bluetooth low energy) – RX
- 5.10 2-Mbps GFSK (Bluetooth low energy) – TX
- 5.11 IEEE 802.15.4 (Offset Q-PSK DSSS, 250 kbps) – RX
- 5.12 IEEE 802.15.4 (Offset Q-PSK DSSS, 250 kbps) – TX
- 5.13 24-MHz Crystal Oscillator (XOSC_HF)
- 5.14 32.768-kHz Crystal Oscillator (XOSC_LF)
- 5.15 48-MHz RC Oscillator (RCOSC_HF)
- 5.16 32-kHz RC Oscillator (RCOSC_LF)
- 5.17 ADC Characteristics
- 5.18 Temperature Sensor
- 5.19 Battery Monitor
- 5.20 Continuous Time Comparator
- 5.21 Low-Power Clocked Comparator
- 5.22 Programmable Current Source
- 5.23 DC Characteristics
- 5.24 Thermal Resistance Characteristics for MOH Package
- 5.25 Timing Requirements
- 5.26 Switching Characteristics
- 5.27 Typical Characteristics
- 6 Detailed Description
- 7 Application, Implementation, and Layout
- 8 Device and Documentation Support
- 9 Mechanical Packaging and Orderable Information
- Important Notice
PRODUCTPREVIEW
28
CC2650MOD
SWRS187 –AUGUST 2016
www.ti.com
Submit Documentation Feedback
Product Folder Links: CC2650MOD
Detailed Description Copyright © 2016, Texas Instruments Incorporated
(1) Up to 13 pins can be connected to the Sensor Controller. Up to eight
of these pins can be connected to analog modules
Table 6-1. GPIOs Connected to the Sensor Controller
(1)
ANALOG CAPABLE 16.9 × 11 MOH DIO NUMBER
Y 14
Y 13
Y 12
Y 11
Y 9
Y 10
Y 8
Y 7
N 4
N 3
N 2
N 1
N 0
6.6 Memory
The flash memory provides nonvolatile storage for code and data. The flash memory is in-system
programmable.
The SRAM (static RAM) can be used for both storage of data and execution of code and is split into two
4KB blocks and two 6KB blocks. Retention of the RAM contents in standby mode can be enabled or
disabled individually for each block to minimize power consumption. In addition, if flash cache is disabled,
the 8KB cache can be used as a general-purpose RAM.
The ROM provides preprogrammed embedded TI-RTOS kernel, Driverlib and lower layer protocol stack
software (802.15.4 MAC and Bluetooth low energy Controller). The ROM also contains a bootloader that
can be used to reprogram the device using SPI or UART.
6.7 Debug
The on-chip debug support is done through a dedicated cJTAG (IEEE 1149.7) or JTAG (IEEE 1149.1)
interface.