AMPAK Technology Inc. Advanced Module Packaging Solution 正基科技股份有限公司 CC2564MODN User manual Revision History Date Revision Content Revised By Version 2010/07/26 Initial released Andy 0.1 2011/12/02 Modify circuit Andy 1.0 AMPAK Technology Inc. www.ampak.com.tw Doc.
Contents 1. PERIPHERAL INTERFACE HIGHLIGHT .................................................................................................. 3 2. FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT ............................... 5 3. INDUSTRY CANADA STATEMENT ..............................................................................................................
1. Peripheral interface highlight ● Power Source: A single host power supply can be used (including VBAT ranging from 3.0V to 4.8V) for CC2654MODN module and external VDD18 to 1.8V supplies for GPIO by host power. Power topology is shown as below figure. ● Bluetooth UART: External patches may be downloaded from the host to the CC2654MODN through the UART transports and connection interface is shown in above reference design circuitry. Support adjustable baud rates from 9600bps to 4Mbps.
● BT debug pin: The debug interface (TX_DBG) helps customers to debug the HW/SW issues for their application. ● Bluetooth PCM: The PCM Interface on the CC2654MODN can connect to linear PCM Codec devices in master or slave mode. In master mode, the CC2654MODN generates the PCM_CLK and PCM_SYNC signals, and in slave mode, these signals are provided by another master on the PCM interface and are inputs to the CC2654MODN.
2. Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This device is intended only for OEM integrators under the following conditions: 1) The transmitter module may not be co-located with any other transmitter or antenna, As long as 1 condition above is met, further transmitter test will not be required.
3. Industry Canada statement This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
This device is intended only for OEM integrators under the following conditions: 1) The transmitter module may not be co-located with any other transmitter or antenna. As long as 1 condition above are met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed.
Le produit final doit être étiqueté dans un endroit visible avec l'inscription suivante: "Contient des IC:451I-2564N". Manual Information to the End User The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user’s manual of the end product which integrates this module. The end user manual shall include all required regulatory information/warning as show in this manual.
