User's Manual

10. Select TX Power
On the transmitter, select desired output power.
11. Select Burst Size
On the transmitter, select the desired burst size,
that is, the number of packets to transmit.
12. Select Packet Rate
On the transmitter, select the desired packet
rate.
13. Start Sending Packets
The transmitter is now configured and in idle
state. Sending packets is started/stopped by
pressing the Select button.
15. PER Test Results
On the receiver, the statistics window will show
the error rate based on the number of lost or
erreneous packets divided by the total number of
packets that should have been received.
18. References
Please visit
www.ti.com and
http://www.ti.com/tool/cc2538dk
On the kit product page, you will find additional
documentation, links to updated software
examples and software tools like SmartRF
Studio.
You will also find a lot of information on the TI
E2E forum at
http://e2e.ti.com
We hope that you will enjoy working with the
CC2538 device.
17. Troubleshooting
It you are experiencing problems with this test,
please check the following:
 Nothing is shown in the display! Make sure
the board is powered correctly (see steps 5
and 6 above).
 Please visit the kit web page and check for
updated SW and documentation. Updated
SW can be downloaded to the device using
IAR EWARM or SmartRF Flash
Programmer.
SmartRF™ Studio
1. Download and Install
Before connecting SmartRF06EB to your PC,
download and install SmartRF Studio from
www.ti.com/smartrfstudio.
2. Launch SmartRF Studio
After installing the tool, connect the EB to the PC
using the USB cable and start SmartRF Studio.
Select the “2.4 GHz” tab and double click the
highlighted CC2538 device icon.
3. Test the Radio
You can now configure the radio, run
performance tests, export register settings and
run link tests with another CC2538 on a
SmartRF06EB connected to the PC.