User's Manual

10/21
a. For the Z-stack: Add the following line to the "Post-build command line":
"$PROJ_DIR$\tools\znp.bat" "$PROJ_DIR$\tools" "CC2531-ProdSBL"
b. For the RemoTI stack:Add the following line to the "Post-build command line":
"$PROJ_DIR$\pp_cc2531f256sb.bat" "$PROJ_DIR$"
8. Now select "Linker" category in the left panel
a. For the Z-stack : in the Ouput tab, in the Format section, select Other, then Output Format:
simple-code and Format variant: None