Users Manual
Table Of Contents
- /
- ENGLISH
- NAVIGATOR TXT MULTIHUB TECHNICAL MANUAL
- 1 Revision of the Manual
- INTRODUCTION
- 2 LEGEND OF THE SYMBOLS USED
- 3 SAFETY RULES
- 4 OPERATION OF THE RADIO DEVICES
- 5 ENVIRONMENTAL INFORMATION
- 6 NORMATIVE INFORMATION
- 7 NAVIGATOR TXT MULTIHUB
- 8 DESCRIPTION
- 9 TECHNICAL FEATURES
- 10 DISPLAY
- 11 POWER SUPPLY
- 12 POWER ON/OFF
- 13 COMMUNICATION
- 14 DIAGNOSIS
- 15 FIRMWARE UPDATE
- 16 MAINTENANCE
- 17 TROUBLESHOOTING
- 18 LEGAL NOTICES
- ENGLISH
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
The VCI does not
communicate with the
display unit.
The display unit is off. Turn on the display unit.
The communication configuration
procedure has not been carried
out.
Perform the communication
configuration procedure.
The VCI and the display unit are
outside the Wi-Fi/Bluetooth
signal range.
Move the VCI and the display
unit closer.
The VCI was placed near
shielding materials.
Place the VCI away from
shielding materials.
Other wireless communications
are disturbing the signal.
Move away from possible
sources of interference.
If possible, switch off the
devices causing the
interference.
Wait and try to communicate
again.
The cable used for the connection
is not properly connected to the
VCI or the display unit.
Make sure the connectors are
paired properly.
The cable used for the connection
is faulty.
Replace the cable.
The USB cable is connected to
the USB connector of the VCI.
Connect the cable to the USB
DEVICE connector.
You chose to manually select a
communication mode that is not
available at the moment.
Set the automatic selection of
communication modes.
Manually select one of the
available communication
modes.
53
en