Users Manual

The analysis of the collected data is performed by the specific software.
In order to analyse the results of the dynamic tests, you must connect the VCI to the display
unit and download the recorded data.
The software allows you to view specific reports for the data stored.
20. Keep the VCI connected to the OBD socket.
21. Connect the VCI to the display unit via Wi-Fi, Bluetooth or USB.
(If previously configured, the wireless connection is automatic)
22. Start the diagnostic software.
For further information, see the software operating manual.
The analysis of the collected data can be carried out at a later
time, also powering the VCI in a different way from the one
described. However, we recommend carrying out these
operations as described so far.
14.5 Disconnection at the End of a Diagnosis
Once the diagnostic operations are complete, disconnect the VCI and restore the initial
vehicle conditions.
Proceed as follows:
1.
Close the diagnostic software.
2.
Turn off the vehicle (instrument panel off).
3.
Disconnect the diagnostic cable from the vehicle's diagnostic connector.
4.
Disconnect the diagnostic cable from the DIAGNOSIS connector on the VCI.
5.
Reposition any panels protecting the OBD connector.
The unexpected unfastening of any panels protecting the
OBD connector may expose to the risk of hindrance to
driving, and in particular to the activation of safety
devices.
Make sure any panels protecting the OBD connector that
were previously removed and then reinstalled are
secured in place, so that they do not fall off while driving.
49
en