Users Manual

TEXA S.p.A. is not, under any circumstance, liable for repair
and maintenance work carried out on vehicles using the
Technical Information and/or Services offered by the specific
websites of each manufacturer. In this respect, the use of
Pass-Thru mode is subject to the acceptance of specific
Liability regulations defined by each vehicle manufacturer.
14.4 Dynamic Tests
The REC mode of the VCI allows checking the vehicle's behaviour during its normal use.
The VCI can acquire and store data relating to the tests through the OBD connector of the
vehicle to which it is connected.
The data that can be stored includes the following:
•
Engineering Parameters
•
Errors
•
states
The data to be stored will be selected by the operator through a specific function in the
diagnostic software.
Some information may not be acquirable or have a delayed
recording during a dynamic test due to the operating strategy
of the control unit.
The operating strategy is defined by the vehicle manufacturer.
Using the VCI in this mode requires different phases that must be carried out correctly and
in the order described:
As an example, below you will find the operating procedure of the VCI in case of a test carried
out with the following specifications:
•
car;
•
Wi-Fi communication between VCI and display unit already configured.
The safety indications below must be adapted based on
the type of vehicle you wish to test.
In particular, refer to the contents in the chapter SAFETY
RULES and in the DISCLAIMER.
45
en