Users Manual

Reprogramming or calibrating the control units may require
you to download specific files from the vehicle manufacturer's
website.
A high-speed connection to the Internet is highly
recommended.
The vehicle manufacturer is entitled to request specific documentation to independent vehicle
repairers (e.g.: Chamber of Commerce company registration showing that the company is
actually registered in the register of vehicle repairers) so that they can carry out
reprogramming operations on security systems (e.g.: immobiliser and/or antitheft control
units).
The full compliance with the J2534-1 standard of the VCI that you purchased allows you to
carry out operations using the diagnostic cable indicated by the software.
If operating on vehicles using the J2534-2 standard for the CAN Single Wire reprogramming,
an optional cable may be required to connect to the PV connector.
When using theVCIforPass-Thruoperations, the
communication with the display unit can only be established
via USB through the specific cable connected to the
connector USB DEVICE.
During the reprogramming operations, it is essential that:
•
the vehicle's supply voltage remains constant throughout the operations; if necessary,
use an external power adapter to charge the vehicle's battery;
•
the vehicle's electrical system is efficient and working properly;
•
the Internet connection is stable and suitable for the operations required;
•
the instructions provided by the vehicle manufacturer are followed to the letter step by
step.
The VCI displays the following screen when in Pass-Thru mode.
Reprogramming or calibrating the control units is an
extremely delicate operation that may cause serious
damage to persons or things if not performed properly.
Carefully follow the indications by the vehicle
manufacturer for every aspect of the reprogramming
procedure and in general for every operation in Pass-
Thru.
For further information, please refer to the documentation provided by the
vehicle manufacturer.
44