Users Manual
Table Of Contents
- /
- ENGLISH
- NAVIGATOR TXT MULTIHUB TECHNICAL MANUAL
- 1 Revision of the Manual
- INTRODUCTION
- 2 LEGEND OF THE SYMBOLS USED
- 3 SAFETY RULES
- 4 OPERATION OF THE RADIO DEVICES
- 5 ENVIRONMENTAL INFORMATION
- 6 NORMATIVE INFORMATION
- 7 NAVIGATOR TXT MULTIHUB
- 8 DESCRIPTION
- 9 TECHNICAL FEATURES
- 10 DISPLAY
- 11 POWER SUPPLY
- 12 POWER ON/OFF
- 13 COMMUNICATION
- 14 DIAGNOSIS
- 15 FIRMWARE UPDATE
- 16 MAINTENANCE
- 17 TROUBLESHOOTING
- 18 LEGAL NOTICES
- ENGLISH
Proceed as follows:
1.
Start the diagnostic software.
2.
Select the vehicle you wish to work on.
3.
Select the system you wish to diagnose.
4.
Select the desired variant.
5.
Connect the VCI to the vehicle following the support information provided by the
software.
6.
Select the DoIP diagnosis.
The VCI displays one of the following screens, based on the selected communication mode.
TheDoIPdiagnosis can be carried out even when the VCI is
directly connected to the display unit, that is in hotspot mode;
however, in this mode it is impossible to access the Internet,
therefore the functions that are available are limited.
For further information, see the software operating manual.
41
en