Users Manual
Table Of Contents
- /
- ENGLISH
- NAVIGATOR TXT MULTIHUB TECHNICAL MANUAL
- 1 Revision of the Manual
- INTRODUCTION
- 2 LEGEND OF THE SYMBOLS USED
- 3 SAFETY RULES
- 4 OPERATION OF THE RADIO DEVICES
- 5 ENVIRONMENTAL INFORMATION
- 6 NORMATIVE INFORMATION
- 7 NAVIGATOR TXT MULTIHUB
- 8 DESCRIPTION
- 9 TECHNICAL FEATURES
- 10 DISPLAY
- 11 POWER SUPPLY
- 12 POWER ON/OFF
- 13 COMMUNICATION
- 14 DIAGNOSIS
- 15 FIRMWARE UPDATE
- 16 MAINTENANCE
- 17 TROUBLESHOOTING
- 18 LEGAL NOTICES
- ENGLISH
The following screen indicates that the VCI is connected to the display unit in the desired
mode and is awaiting commands.
For further information, see the software operating manual.
13.4 USB
The connection via USB between the tool and the display unit can only be established
through the USB DEVICE connector.
The USB connector is reserved to assistance operations and must only be used if specifically
indicated by the Technical Assistance.
In order to connect via USB, you must use the specific cable provided or, if necessary, cables
on which "USB HIGH SPEED" is specifically indicated.
This communication mode is not available for the following
display units:
•
AXONE 5
The connection to the display unit via USB through the USB
DEVICE connector automatically inhibits any activity on the
connector USB.
37
en