Users Manual
Table Of Contents
- /
- ENGLISH
- NAVIGATOR TXT MULTIHUB TECHNICAL MANUAL
- 1 Revision of the Manual
- INTRODUCTION
- 2 LEGEND OF THE SYMBOLS USED
- 3 SAFETY RULES
- 4 OPERATION OF THE RADIO DEVICES
- 5 ENVIRONMENTAL INFORMATION
- 6 NORMATIVE INFORMATION
- 7 NAVIGATOR TXT MULTIHUB
- 8 DESCRIPTION
- 9 TECHNICAL FEATURES
- 10 DISPLAY
- 11 POWER SUPPLY
- 12 POWER ON/OFF
- 13 COMMUNICATION
- 14 DIAGNOSIS
- 15 FIRMWARE UPDATE
- 16 MAINTENANCE
- 17 TROUBLESHOOTING
- 18 LEGAL NOTICES
- ENGLISH
12.2 Boot down
To turn off the VCI, you must disconnect it from the power source.
Proceed as follows:
Disconnect the VCI from the power source.
The VCI turns off.
Generally, if the tool is powered via OBD connector, just turn
off the vehicle by turning the ignition key to the OFF position
(ignition off).
For further information, please refer to the technical
documentation provided by the manufacturer.
Turning off the VCI during specific diagnostic operations
(e.g.: control unit reprogramming) may cause the
operations to fail.
Make sure all diagnostic operations have been
completed before turning off the VCI.
32