Users Manual
Table Of Contents
- /
- ENGLISH
- NAVIGATOR TXT MULTIHUB TECHNICAL MANUAL
- 1 Revision of the Manual
- INTRODUCTION
- 2 LEGEND OF THE SYMBOLS USED
- 3 SAFETY RULES
- 4 OPERATION OF THE RADIO DEVICES
- 5 ENVIRONMENTAL INFORMATION
- 6 NORMATIVE INFORMATION
- 7 NAVIGATOR TXT MULTIHUB
- 8 DESCRIPTION
- 9 TECHNICAL FEATURES
- 10 DISPLAY
- 11 POWER SUPPLY
- 12 POWER ON/OFF
- 13 COMMUNICATION
- 14 DIAGNOSIS
- 15 FIRMWARE UPDATE
- 16 MAINTENANCE
- 17 TROUBLESHOOTING
- 18 LEGAL NOTICES
- ENGLISH
11.1.4 Cigar lighter cable
The VCI can be powered by the battery in the vehicle being tested using the PWR connector.
The image is only an example: the position of the cigar lighter
socket may change based on the vehicle being tested.
Always refer to the documentation supplied by the vehicle
manufacturer for the positioning and correct access to the
cigar lighter socket.
Make sure the cigar lighter socket is powered even when the
ignition key is on OFF (instrument panel off).
Proceed as follows:
1.
Connect the cigar lighter cable to the PWR connector.
2.
Connect the cigar lighter cable to the cigar lighter socket in the vehicle being tested.
In this case the green LED on the connector for the lighter socket will also turn on.
The VCI displays the following screen if no communication modes with the display unit have
been configured.
30