Users Manual
Table Of Contents
- /
- ENGLISH
- NAVIGATOR TXT MULTIHUB TECHNICAL MANUAL
- 1 Revision of the Manual
- INTRODUCTION
- 2 LEGEND OF THE SYMBOLS USED
- 3 SAFETY RULES
- 4 OPERATION OF THE RADIO DEVICES
- 5 ENVIRONMENTAL INFORMATION
- 6 NORMATIVE INFORMATION
- 7 NAVIGATOR TXT MULTIHUB
- 8 DESCRIPTION
- 9 TECHNICAL FEATURES
- 10 DISPLAY
- 11 POWER SUPPLY
- 12 POWER ON/OFF
- 13 COMMUNICATION
- 14 DIAGNOSIS
- 15 FIRMWARE UPDATE
- 16 MAINTENANCE
- 17 TROUBLESHOOTING
- 18 LEGAL NOTICES
- ENGLISH
If the battery is in the rear part of the vehicle, we recommend
connecting the VCI directly to the power supply points coming
from the battery that are available near the area in which you
are operating.
Use the battery power only when specifically requested by the
software.
Be careful to respect the polarities indicated on the cables
when connecting to the battery terminals.
Proceed as follows:
1.
Connect the diagnostic cable to the DIAGNOSIS connector.
2.
Connect the power supply cable to the diagnostic cable.
3.
Connect the cable clamps to the battery terminals.
Incautious operations may expose the operator to the
risk of electric shock, even though of low intensity.
Be very careful when connecting the clamps to the
battery terminals.
The VCI displays the following screen if no communication modes with the display unit have
been configured.
29
en